Project note

Automatic Litter Box 3.0 – The Outer Box and a Taller Drawer

Version 3.0 of the automatic litter box continues with the outer box: splitting it into printable puzzle pieces, cutting the front drawer opening, and raising the collection drawer past the printer's 28 cm height limit.

5 tags
Tags

🐈 Automatic Litter Box 3.0 – Splitting the Outer Box Into Pieces

The 3.0 redesign is moving forward.

This round was all about the outer box. Breaking it down into printable pieces, cutting the opening for the collection drawer, and dealing with a height problem the printer handed me halfway through.


🧩 Splitting the Outer Box Into Puzzle Pieces

This image shows how I split the outer box itself into puzzle pieces, where I also made the holes for the screws:


🌀 The Filter Inside the Rotating Box

This image shows the filter on the inside of the cylinder-shaped box that spins:


🚪 The Drawer Opening in the Front

This image shows how I made a hole in the front, where you pull the drawer that collects the litter in bags in and out:

🔎 The Inner Part in Practice

This image shows how the inner part looks in practice:


📏 Raising the Collection Drawer

I realized fairly early that the drawer collecting the cat litter in bags was too low.

So I had to raise the whole part. Since the printer cannot handle anything taller than 28 cm, I had to come up with a solution to print it in several steps.

But now the collection drawer is taller and can hold more litter:

This one shows the before and after in practice:


🔜 Next Step

Continue make more holes... also prepare might for an simulation/animation where I testing the physics that the sand sips through the filter probably...

Comments

Comments

Loading comments…